Spanish for sweat lodge, settled by Leandro Serrano around 1819
Concrete Contractors in Temescal Valley, CA
Patios, pool decks and driveways at 1,138 feet, where homes back up to the Santa Ana Mountains.
- Free on-site estimates with measurements and a base check
- Written, itemized quote before any work starts
- Pours and curing planned around Inland Empire heat
Concrete South of Corona, Up the Canyon
Temescal Valley runs along Temescal Canyon south of Corona, and concrete contractors working here deal with hotter summers, higher ground and more slope than in the flatlands to the north. The community sits at about 1,138 feet and covers roughly 19.4 square miles. It became a census-designated place in 2010 and had 26,232 residents by 2020, up 16.4% in a decade. Owners occupied 86.5% of homes at the last census.
A long history, newer houses
The name is Spanish for sweat lodge. Leandro Serrano took possession of Rancho Temescal around 1818 or 1819, and the Serrano Boulder, California Historical Landmark #185, marks the site of his first house. The valley later held a Butterfield Overland Mail stage station, orchards and bee-keeping, and the Temescal Tin Mine. The housing came much later. What that means for concrete is that most slabs here are relatively young, poured over graded pads on former ranch and canyon land.
Graded pads and hillside backyards
Many Temescal Valley lots step up or down from the street, with the Santa Ana Mountains rising behind them. Graded lots have a mix of cut ground and placed fill. Fill that was compacted well holds a slab fine; fill that was not can settle. Before we pour a large patio or pool deck near the top or bottom of a slope, we:
- Probe and compact the subgrade where the new slab will sit
- Keep the slab back from the slope edge or add a thickened edge
- Plan where roof and yard water will go so it does not run under the slab
- Use rebar rather than mesh on larger slabs to hold any future cracks tight
Built for the heat
The climate table for Temescal Valley shows July highs averaging 94 degrees and a record of 114, which was set in September. That late heat matters, because fall is when many owners schedule patio work. We pour early in the day, use a curing compound or wet cure right away, and keep fresh stamped concrete shaded from the afternoon sun when we can. Rain is light, about 14.77 inches a year, and most of it falls between November and March, so winter is often a good time to pour as long as the ground is not saturated.
Pool decks and outdoor rooms
With an average household size of 3.18 and more than 83% of households being families, backyard pools and covered patios are common upgrades. Our pool decks get a textured, non-slip finish and a lighter color or cool-deck coating to keep surface temperatures down. Stamped concrete in slate or flagstone patterns pairs well with the stone and earth tones of the surrounding hills. We seal stamped work after it cures to protect the color from sun and pool chemicals.
Driveways on a grade
A sloped driveway needs more than a steeper pour. We use a coarse broom finish across the slope for traction, add control joints that follow the grade, and make sure the transition at the garage and at the street does not scrape a car. Where a driveway drains toward the garage, we can add a trench drain at the bottom.
Part of Temescal Valley is served by the Corona-Norco Unified School District and part by Lake Elsinore Unified, which shows how the community spans the area between the two cities. We work across all of it and check Riverside County permit needs for each project before we start.
Temescal Valley Details
- Growing CDP. Temescal Valley had 22,535 residents in 2010 and 26,232 in 2020, a 16.4% increase, across about 19.4 square miles.
- Owners, not renters. Of 8,475 housing units counted in 2020, 86.5% of occupied homes were owner-occupied and the homeowner vacancy rate was 1.1%.
- Higher and hotter. The community sits at about 1,138 feet. July highs average 94°F, and the record high is 114°F, set in September.
- Historic ranch land. Rancho Temescal dates to about 1819, and the Serrano Boulder is California Historical Landmark #185.

Our Services in Temescal Valley, CA
Temescal Valley Questions
Is it safe to pour a patio near the slope in my Temescal Valley backyard?
Usually, with the right prep. We compact the subgrade, keep the slab back from the edge or thicken it there, and plan drainage so water does not undercut the slab. If the slope shows signs of movement, we will tell you before quoting.
Which season is easiest for pouring concrete in Temescal Valley?
Spring and late fall are easiest, but we pour year-round. In hot months we start early and cure the slab right away. In winter we wait for the ground to dry out after a storm.
Does Temescal Valley follow Corona's permit rules?
Temescal Valley is an unincorporated area, so projects there generally fall under Riverside County rather than the City of Corona. We confirm with the county for your project before we schedule.
Free Estimates in Temescal Valley, CA
Free estimates throughout Temescal Valley, from the Corona line down the canyon.
Concrete Contractors Near Temescal Valley
- Concrete Contractors in Corona, CA
- Concrete Contractors in Norco, CA
- Concrete Contractors in Eastvale, CA
- Concrete Contractors in Riverside, CA
- Concrete Contractors in Chino Hills, CA
- Concrete Contractors in Chino, CA
- Concrete Contractors in Yorba Linda, CA
- Concrete Contractors in Home Gardens, CA
- Concrete Contractors in Woodcrest, CA
- Concrete Contractors in El Sobrante, CA
- Concrete Contractors in Jurupa Valley, CA
- Concrete Contractors in Lake Elsinore, CA
- Concrete Contractors in Moreno Valley, CA
- Concrete Contractors in Perris, CA
- Concrete Contractors in Lake Mathews, CA
- Concrete Contractors in Anaheim, CA
- Concrete Contractors in Ontario, CA
- Concrete Contractors in Placentia, CA
- Concrete Contractors in Brea, CA
- Concrete Contractors in Orange, CA
- Concrete Contractors in Diamond Bar, CA